Download Print this page
Siemens SIMATIC FM 350-2 Quick Start Up Manual
Siemens SIMATIC FM 350-2 Quick Start Up Manual

Siemens SIMATIC FM 350-2 Quick Start Up Manual

Counter function module
Hide thumbs Also See for SIMATIC FM 350-2:

Advertisement

Quick Links

s
SIMATIC
FM 350-2 Counter Function Module
Getting Started
Edition 12/2003
Quick Startup Guide

Advertisement

loading
Need help?

Need help?

Do you have a question about the SIMATIC FM 350-2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Siemens SIMATIC FM 350-2

  • Page 1 SIMATIC FM 350-2 Counter Function Module Getting Started Edition 12/2003 Quick Startup Guide...
  • Page 2 Trademarks SIMATIC®, SIMATIC HMI® and SIMATIC NET® are registered trademarks of SIEMENS AG. Third parties using for their own purposes any other names in this document which refer to trademarks might infringe upon the rights of the trademark owners.
  • Page 3 This guide uses a specific example to introduce you to starting up your FM 350-2 module. It uses four steps to lead to a functioning application in which you count the switching operations of a contact and become familiar with and test the basic functions of the hardware and software of your FM 350-2.
  • Page 4 Insert the front connector in the FM 350-2 and screw it in place. Test: Switch on the voltage on the power supply module. The red LED SF lights up briefly and extinguishes after the internal module test has been run successfully. Once you have switched on the power supply for the first time, the FM 350-2 has the default parameters assigned (the features of the default parameter assignment are described in Section 5.2 of the manual).
  • Page 5 Confirm the settings with OK: • Specify Channels: Channels 0 to 7 as Single Counter The following settings apply to channel 0. • Operating Modes: Continuous Counting Use Hardware Gate • Encoders: Pulse and Direction Main Count Direction Up • Interrupt Enable: not possible as deselected in basic parameters •...
  • Page 6 PLC → Download your program to the CPU using the menu command Download. Test: Using the “Monitoring and Modifying Variables” application you can now monitor the count value and the gate, for example: In your project select the “Blocks” container. Insert the variable table VAT1 using the Insert →...