Silvercrest SSWR C2 User Manual page 20

˜ Using the mop function
(Fig. H)
NOTES:
For hygienic reasons, remove the water
o
tank from the product immediately after
[ ]
using the mop function.
You can use the mop function together with
o
any of the 3 cleaning modes (see "Cleaning
modes").
1. Remove the floor cloth
of the water tank
[
2. Open the rubber cover
3. Fill the water tank
[
4. Close the rubber cover
5. Reinstall the floor cloth
of the water tank
[
6. Install the water tank
the product. Place the 2 pins
matching 2 holes on the product.
7. After using the mop function, remove the
water tank from the product.
[ ]
8. Open the rubber cover
remaining water.
˜ Setting a vacuuming schedule
NOTES:
You can set a schedule so that the product
o
starts to clean automatically.
Signal tones sound if the time and schedule
o
have been successfully set. If this does not
happen, the settings have not been stored.
If you do not press any button within approx.
o
15 seconds while setting the time or a
schedule, the setting ends automatically and
no information is stored.
If you switch off the product by setting the
o
to O position (off), the time
on/off switch
[ ]
setting and vacuuming schedule will be erased.
Setting the current weekday and time
1. Ensure the product is in standby mode (see
"Indicator lights on the product").
If the product is in sleep mode, press
or to enter standby mode.
[ ]
20 GB/IE/NI
at the bottom side
[ ]
.
]
.
[ ]
with water.
]
.
[ ]
at the bottom side
[ ]
.
]
at the bottom of
[ ]
into the
[ ]
. Pour out the
[ ]
2 ] [
2. Press to enter time setting mode.
[ ]
lights up and the preset weekday
[ ]
flashes on the display
an acoustic signal for confirmation.
3. Select the current weekday by pressing
or .
[ ] [ ]
Display
SUN
MON
TUE
WED
THU
FRI
SAT
4. Press to confirm the setting.
[ ]
5. Set the hours by pressing
6. Press to confirm the setting.
[ ]
7. Set the minutes by pressing
8. Press to store the setting.
[ ]
Setting a schedule
NOTES:
A specific cleaning mode cannot be
o
programmed. Programmed cleaning
processes are always executed in automatic
mode.
If you switch off the product by setting the
o
to O position (off), the
on/off switch
[ ]
time setting and vacuuming schedule will be
erased.
1. Ensure the product is in standby mode (see
"Indicator lights on the product").
If the product is in sleep mode, press
or to enter standby mode.
[ ]
2. Press to enter schedule setting mode.
[ ]
lights up and the weekday
[ ]
on the display . A placeholder for the time
[ ]
is displayed.
3. Select a weekday by pressing
. The selected weekday flashes. To
[ ]
store the selected weekday, press
4. Optional: Repeat the previous step for all
desired days of the week.
[ ]
. The product emits
[ ]
Weekday
Sunday
Monday
Tuesday
Wednesday
Thursday
Friday
Saturday
or .
[ ] [ ]
or .
[ ] [ ]
2 ] [
flashes
[ ]
or
[ ]
.
[ ]