NEC VERSA 4200 Manual page 91

NOTE
When you connect a printer, be sure to install the appropriate
printer driver through the Windows Control Panel.
Connect a parallel device to your NEC Versa 4200 as follows.
Check that both the NEC Versa and parallel device's power are off.
1.
Open the port cover on the back of the system and locate the parallel
2.
port.
Align and connect the 25-pin parallel cable connector to the parallel port
3.
on the system. Secure the cable with the screws provided.
Align and connect the other end of the cable to the parallel port on
4.
the device. Lock the connector clips.
5. Connect the power cable to the device and a properly grounded wall out-
let.
6. Turn on power to the system and the device.
Connecting a parallel printer
Using the Hardware 4-25