Using The Update Utility - NEC VERSA 4000 Service Manual

2-18 Setup and Operation
At the File Menu, type D and then press Enter for download.
4.
Type the file name, L440 n B3.EXE, and press Enter. Insert the correct revision
5.
number in place of the n.
Press Enter again.
6.
Set the default protocol on the BBS.
7.
8. The BBS displays a prompt that it is ready to send the file. Perform the software's
download transfer procedure. The files are sent to the hard drive. Execute the file
to create a bootable disk. A message prompts you to insert a 1.44-MB diskette
drive in drive A. Make sure that it is a high-density diskette. Press any key to
continue.
After pressing any key, the diskette is formatted and the BIOS update files are
copied to the diskette.
9. After the download is completed, log off the BBS.

Using the Update Utility

Load the BIOS Update utility as follows.
1. Power off the system unit.
Make sure Switch 1 on the dip switch is off.
2.
Insert the BIOS Update Utility diskette into drive A.
3.
4. Power on the system unit. The unit boots and automatically loads the utility. A
message similar to the following appears:
NOTE: If you don't know the filename, join the
laptop conference to find the BIOS or driver disk
you need.
CAUTION: Never load a BUU from another
system model. That system's BIOS will be lost.
FLASH ROM EQUIPPED
WARNING: The BIOS Update Procedure
is about to begin, press ENTER to continue.
To abort, remove the diskette and reset the unit.