Table of Contents
Advertisement
T
to check the installation of optional memory by
comparing the amount of memory installed with the
amount of memory displayed by Setup
T
to change certain system operating parameters, such as
boot device sequence and keyboard parameters
T
to configure system connections for peripherals such as
your diskette drive, hard disks, and devices connected to
the printer port and serial ports
T
to customize your system with security features such as
passwords, diskette drive restriction, virus check
reminder and system backup reminder
T
to set system parameters in the event that you need to
replace the installed complimentary metal oxide
semiconductor (CMOS) battery.
How to Start Setup
To start the Setup utility, follow these steps:
Turn on or reboot the system.
1.
Press
2.
start the memory test.
You have about five seconds to press
boot continues.
Setup's Main Menu appears and looks similar to the
3.
following screen.
after POST, but before the system boots up, to
F1
before system
F1
NEC Drivers and Utilities 4-3
Advertisement
Table of Contents
