Replacing The Retainer Bar - NEC POWERMATE ES User Manual
A versatile, highly serviceable pc
Hide thumbs
Also See for POWERMATE ES:
- Service and reference manual (132 pages) ,
- Configuration manual (1 page) ,
- Release note (8 pages)
Table of Contents
Advertisement
Replacing the Retainer Bar
To install the retainer bar, use the following steps.
Holding the retainer bar at an angle, position its legs near the slots in
1.
the chassis (see the following figure).
Push the bar so the legs go in the slots and the top of the bar slides
2.
under the edge of the chassis.
It may be helpful to press down on the locking tabs as the bar is
positioned.
A – Retainer Bar Leg
B – Slot for Retainer Bar Leg
Make sure the ridges on the locking tabs snap into the slots on the
3.
edge of the chassis.
4.
Replace the cover (see "Replacing the Cover").
4-16 Installing Options
Positioning the retainer bar
C – Ridge on Tab
D – Slot in Chassis
Advertisement
Table of Contents
