Changing Network Settings On Systems With Windows Nt; Changing Network Settings On Systems With Windows 2000 - NEC POWERMATE 2000 - RELEASE NOTES 05-2000 Release Note

Changing Network Settings on Systems with Windows NT

All systems are configured with the NetBEUI and NWLink protocols enabled. However, before
you connect a system to your network you might need to:
T
enable a different network protocol
T
disable unneeded protocols for enhanced system performance
T
add or change network, domain, and gateway information.
The following procedure describes how to disable the NetBEUI and NWLink protocols, enable
TCP/IP, and provide network, domain, and gateway information. (If a different protocol is
enabled, the menu choices might differ from those described in the procedure.)
1. From the Windows desktop, click
Panel .
Double click the
2.
3. Click the
loaded:
NetBEUI Protocol
NWLink IPXSPX-Compatible Transport
NWLink NetBIOS
Highlight
4.
appears asking for confirmation to continue.
5. Click Yes
disappear from the Configuration display.
Repeat steps 4 and 5 to remove the NetBEUI Protocol.
6.
7. In the Configuration tab display, click
Highlight
8.
there is a DHCP server on the network, click
9. Change the path in the window to
If Yes was clicked in step 8, skip to step 16. If No was clicked in step 8, the Windows Setup
window appears.
10. Click Close
11. Fill in the
address" area.
Click the
12.
13. Click the
14. Click the
Click the
15.
Click
16. OK

Changing Network Settings on Systems with Windows 2000

All systems are configured with the NetBEUI and NWLink protocols enabled. However, before
you connect a system to your network you might need to:
T
enable a different network protocol
T
disable unneeded protocols for enhanced system performance
T
add or change network, domain, and gateway information.
2 NEC PowerMate 2000 Series Release Notes
Start
icon in the Control Panel window.
Network
Configuration tab. In the Configuration display, the following protocols are
NWLink IPXSPX-Compatible Transport
. The NWLink IPXSPX-Compatible Transport and NWLink NetBIOS lines
and then
Microsoft TCP/IP
C:\I386
. The Microsoft TCP/IP Properties Box appears.
IP Address , the Subnet Mask
tab and enter the host and domain name in the DNS display.
DNS
Identification tab and change the Computer Name if appropriate.
WINS tab and enter the WINS address if appropriate.
tab and enable IP forwarding if appropriate.
Routing
. When prompted to restart the system, click
on the taskbar, point to Settings
and click
Remove
Add . Highlight Protocol
and click . The TCP/IP Setup window appears. If
OK
; otherwise click
Yes
. Click Continue . The Network window appears.
, and the Default Gateway
.
Yes
, and click Control
. A warning window
and click Add .
.
No
in the "Specify an IP