Advertisement
Installation and Operation Manual
Manual P/N 5900013 — Manual Revision A — February 2019
Models:
• RJS-3T
• RJS-6T
• RJS-12T
Designed and engineered by BendPak Inc. in Southern California, USA. Made in China.
⚠
DANGER
Heavy-Duty Jack Stands
entire
Read the
product. Failure to follow the instructions and safety precautions in
this manual can result in serious injury or death. Make sure all other
operators also read this manual. Keep the manual near the product
for future reference. By proceeding with setup and operation, you
agree that you fully understand the contents of this manual.
contents of this manual
1645 Lemonwood Dr.
Santa Paula, CA 93060 USA
Toll Free: (800) 253-2363
Tel: (805) 933-9970
rangerproducts.com
Model RJS-12T shown.
before
using this
Advertisement
Table of Contents
Related Manuals for BendPak Ranger RJS-3T
Summary of Contents for BendPak Ranger RJS-3T
- Page 1 Manual P/N 5900013 — Manual Revision A — February 2019 Models: • RJS-3T • RJS-6T • RJS-12T Model RJS-12T shown. Designed and engineered by BendPak Inc. in Southern California, USA. Made in China. ⚠ entire before Read the contents of this manual using this product.
- Page 2 Copyright. Copyright © 2019 by BendPak Inc. All rights reserved. You may make copies of this document if you agree that: you will give full attribution to BendPak Inc., you will not make changes to the content, you do not gain any rights to this content, and you will not use the copies for commercial purposes.
-
Page 3: Shipping Information
Introduction This manual describes these Jack Stand models: • RJS-3T: Pair of heavy-duty Jack Stands that, used together, support up to 3 tons. • RJS-6T: Pair of heavy-duty Jack Stands that, used together, support up to 6 tons. • RJS-12T: Pair of heavy-duty Jack Stands that, used together, support up to 12 tons. More information about the full line of Ranger Products is available at rangerproducts.com. -
Page 4: Safety Information
BendPak Ranger assumes no liability for damages resulting from: • Use of the equipment for purposes other than those described in this manual. • Modifications to the equipment without prior, written permission from BendPak Ranger. • Damage to the equipment from external influences. •... -
Page 5: Installation
Installation This section describes how to get your Jack Stands ready for use. Installation information applies to all three models. Note: To install your Jack Stands: 1. Remove the Jack Stands and the Ratcheting Posts from the box. 2. Insert each Ratcheting Post into a Jack Stand. 3. - Page 6 1645 Lemonwood Drive Santa Paula, CA 93060 USA Copyright © 2019 by BendPak Inc. All rights reserved. bendpak.com...
Need help?
Do you have a question about the Ranger RJS-3T and is the answer not in the manual?
Questions and answers