HOMCOM 824-047V70 Manual page 6

3. SPEED : You can adjust the fan speed to the desired level: low, medium, or high
by pressing 'SPEED' . The speed setting is displayed on the LED display. (Fig 8)
4. MODE : Pressing the 'MODE' button will set the FAN into NORMAL, NATURAL,
SLEEP and CHILD mode.
- NORMAL Mode
speed you set up.
- NATURAL Mode
speed(5s)→high speed(5s)→medium speed(5s), it works as per this recycle.
- SLEEP Mode
1) If you set the fan at high speed, fan will work at high speed for 30 mins, then the fan
will transfer to medium speed and work for 30 mins, later the fan transfer to low speed
and keep working until the fan stops working.
2) If you set the mode at medium speed, fan will work at medium speed for 30 mins,
then the fan will transfer to low speed and keep working until it stops working.
3) If you set the mode at low speed, fan will work at low speed until the fan stops
working. The LED display will turn off if you don't control the fan in 30 seconds, touch
any button to turn on the display.
- CHILD Mode
start. The fan will work at high speed for 15 minutes, and it will transfer to medium
speed for 15 minutes, then it will transfer to low speed until it is turned off
automatically. You can turn off oscillation function manually. The LED display will turn
off if you don't control the fan in 30 seconds, touch any button to turn on the display.
5. TIMER : The fan is equipped with a timer that allows you to set its length of
operation from 1 hour to 12 hours. The LED display will turn off if you don't control the
fan in 30 seconds, touch any button to turn on the display.
6. OSCILLATION
function. The symbol is displayed on the LED display.
7. COOLING
again to turn off. If you want to operate the unit with water for better cooling, pull out
the water tank and fill it up to the MAX mark at the most. Take care when doing so, to
make sure, that no water enters the product, e.g. through the air inlet.
ATTENTION ABOUT ICE BOX
Then put a ice box in the water tank ( the ice box needs to be frozen for more than 3
hours), and the cooling effect is better ( Note: when the water tank is short of water, it is
forbidden to use, please add water in time).
8. DISPLAY : Can be switched off temporarily by press the LED button on the
remote or by pressing and holding the SPEED button on the control panel for more
than 3 seconds, the display will light up again once any control button is activated.
: The default mode is normal mode. Fan will start work at any
: Fan will start work at low speed(5s) →medium
:
: Fan will auto. set up timer at 3 hours and oscillation function will
: Pressing the 'OSC' button will start and stop the oscillation
: Press 'COOLING' button to turn on the cold air function. Press button
6