Table of Contents
Advertisement
Attaching Mounting Accessories
For shipping purposes, the LCD6520P is shipped with a
temporary stand.
This stand must be removed before installation.
In order to remove the monitor from the temporary
stand and to aid in mounting, a lifting device must be
used in conjunction with the attachable eyebolts.
1. Attach eyebolts
This model is equipped with attachable eyebolts to aid in
mounting.
•
Place the washer over the threads of the eyebolt.
•
Screw the eyebolts into eyebolt holes as shown in the
picture.
•
Be sure eyebolts are secure.
•
In order to move the monitor into position, use a lifting
device attached to the eyebolts.
DO NOT mount the monitor using only the eyebolts.
Use an approved mounting accessory.
Eyebolt
Hole
2. Removing the Temporary Stand
1. To remove stand, unscrew the screws indicated in the
picture.
2. Using a lifting device, raise the monitor off of the stand.
Eyebolt
Washer
Screws
3. Attach Mounting Accessories
The display is designed for use with the VESA mounting
system.
When using mounting accessories other than NEC
compliant and approved, they must comply with the VESA-
compatible mounting method. NEC strongly recommends
using screws M8 size and 15 mm in length. If using screws
longer than 15 mm, check the depth of the hole.
(Recommended Fasten Force: 1125 - 1375N•cm)
NEC recommends using a mounting interface that complies
with UL1678 standard in North America.
NOTE: Do not use the temporary stand holes for
permanent stand installation. These holes are for
shipping purposes only.
4. Ventilation Requirements
When mounting in an enclosed space or recessed area,
leave adequate room between the monitor and the
enclosure to allow heat to disperse, as shown below.
English-10
VESA Mounting
Interface
Advertisement
Table of Contents
