Table of Contents
Advertisement
Attaching Mounting Accessories
The display is designed for use with the VESA mounting
system.
1. Attach eyebolts for mounting
This model is equipped with attachable eyebolts to aid in
mounting.
•
Place the washer over the threads of the eyebolt.
•
Screw the eyebolts into eyebolt holes as shown in the
picture.
•
Be sure eyebolts are secure.
•
In order to move the monitor into position, use a lifting
device attached to the eyebolts.
DO NOT mount the monitor using only the eyebolts.
Use an approved mounting accessory.
Eyebolt
Hole
2. Attach Mounting Accessories
Mounting accessories can be attached while the monitor
is on the Tabletop Stand in the upright position (Figure 1).
Be careful to avoid tipping monitor when attaching
accessories. After accessories are attached, stand can
be removed.
VESA Mounting Interface
Tabletop Stand
Mounting accessories can be attached with the monitor in
the face down position. To avoid damaging the screen face,
place the protective sheet on the table underneath the LCD
(Figure 2). The protective sheet was wrapped around the
LCD in the original packaging. Make sure there is nothing
on the table that can damage the monitor.
When using mounting accessories other than NEC
compliant and approved, they must comply with the VESA-
compatible mounting method. NEC strongly recommends
using screws M8 size and 15 mm in length. If using screws
longer than 15 mm, check the depth of the hole.
(Recommended Fasten Force: 1125-1375N•cm)
NEC recommends using a mounting interface that complies
with UL1678 standard in North America.
Eyebolt
Washer
Figure 1
Table
3. Installing and removing stand
CAUTION: Installing and removing the stand must be done
by four or more people.
How to install stand
1. Please turn monitor off.
2. Place stand onto monitor with the long ends of the feet in
front of the monitor.
3. After inserting stand in guide block, fasten thumbscrews
on both sides of the monitor.
How to remove the stand
1. Spread the protective sheet on a flat surface, such as a
desk.
2. Place monitor on the protective sheet.
3. Remove thumbscrews with a screwdriver or with your
fingers and place them in a safe place for reuse.
Thumbscrews
NOTE: Place stand onto monitor so that the long end of
the feet are in the front.
CAUTION: Handle with care when mounting LCD monitor
stand and avoid pinching your fingers.
English-6
Protective Sheet
Tabletop Stand
Figure 2
Stand
Advertisement
Table of Contents
