Dell Precision X001C Quick Reference Manual page 36

D R I V E C O N T R O L L E R F A I L U R E
C D
commands from the computer.
A T A E R R O R
D —
D E C R E A S I N G A V A I L A B L E M E M O R Y
faulty or improperly seated. Reinstall the memory modules and, if necessary,
replace them. See your Service Manual at support.dell.com for more
information.
D I S K C : F A I L E D I N I T I A L I Z A T I O N
hard drive tests in the Dell Diagnostics (see "Dell Diagnostics" on page 42).
D R I V E N O T R E A D Y
can continue. Install a hard drive in the hard drive bay. See your Service
Manual at support.dell.com for more information.
R R O R R E A D I N G
E
ExpressCard. Reinsert the card or try another card. See your Service Manual
at support.dell.com for more information.
E X T E N D E D M E M O R Y S I Z E H A S C H A N G E D
nonvolatile memory (NVRAM) does not match the memory installed in the
computer. Restart the computer. If the error appears again, contact Dell (see
"Contacting Dell" on page 65).
T H E F I L E B E I N G C O P I E D I S T O O L A R G E F O R T H E D E S T I N A T I O N D R I V E
that you are trying to copy is too large to fit on the disk, or the disk is full. Try
copying the file to a different disk or use a larger capacity disk.
F I L E N A M E C A N N O T C O N T A I N A N Y O F T H E F O L L O W I N G C H A R A C T E R S
A
Do not use these characters in filenames.
> | —
A T E F A I L U R E
G A 2 0
modules and, if necessary, replace them. See your Service Manual at
support.dell.com for more information.
G E N E R A L F A I L U R E
command. The message is usually followed by specific information—for
example, Printer out of paper. Take the appropriate action.
A R D D I S K D R I V E C O N F I G U R A T I O N E R R O R
H -
drive type. Shut down the computer, remove the hard drive (see your Service
Manual at support.dell.com), and boot the computer from a CD. Then, shut
down the computer, reinstall the hard drive, and restart the computer. Run
the Hard Disk Drive tests in the Dell Diagnostics (see "Dell Diagnostics" on
page 42).
36
Troubleshooting
—
The hard drive cannot read the data.
—
—
The operation requires a hard drive in the bay before it
—
C A R D
P C M C I A —
A memory module may be loose. Reinstall the memory
—
The operating system is unable to carry out the
—
The CD drive does not respond to
One or more memory modules may be
The hard drive failed initialization. Run the
The computer cannot identify the
The amount of memory recorded in
—
The computer cannot identify the
—
The file
—
: \ / : * ? " <