If battery is completely discharged or brand new, there could be a few minutes delay before the charging indicator illuminates. This is not an abnormal occurrence.

When the battery voltage falls below the working level, RECHARGE BATTERY appears on the graphics display area and an empty battery icon displays in the status bar.

With the recharge notification, the phone also sounds a short tone at ten-second intervals. Once the recharge message displays and the short tone sounds, the phone

battery has approximately one minute of use remaining. The phone automatically powers Off.

The battery charge continues to drop after the "RECHARGE BATTERY" warning displays. In extreme cases where the battery is left uncharged for some considerable time

after the warning is displayed, a trickle charge is used to slowly charge the battery back up to a safe level at which fast charging can begin. During this time, the battery

icon will show charging but you are not able to make or receive a call, or fully power On the phone. Normal wireless phone operation resumes once fast charging begins.

The phone can be in trickle charge for a few hours before fast charging starts if the battery is left uncharged for some days after the recharge warning.

Changing the Battery

Make sure the phone is turned Off. Some settings, stored numbers, and messages may be lost if the battery is removed while the power is On.

Gently push the indented circle only 1/8 inch towards the hinge end of the wireless phone. (See Picture 1.)

Lift the back cover plate straight up from the wireless phone to reveal the battery location. (See Picture 2.)

At the hinge end of the phone, use the tip of your finger or fingernail to lift the battery up and remove from the battery location. (See Picture 3.)

Place the new battery with the battery terminal end into the battery holder towards the top (away from the hinged end) of the phone. Lower the battery toward

the phone. (Picture 4.)

Lower the back cover plate on the phone . At the hinge end, gently push the back cover plate into place. (Picture 5.)

Do not place the back cover plate on the phone

except as shown in item 2 in the right column.

If you attempt to place the back cover plate on

the phone by any other position, you may

damage the back cover.

Table of Contents