Celestron NexStar SLT Quick Setup Manual

1
Your NexStar includes: optical tube; fork arm, pre-assembled tripod,
computerized hand control, hand control holder, star diagonal, two
eyepieces, fi nderscope, accessory tray, and owner's manual
4
Place the hole in the accessory tray over the bayonet mount on
the tripod's center leg brace. Rotate the accessory tray until the
three locking tabs insert into the locking clips on each section of
the central leg brace.
7
Attach the telescope optical tube by positioning the dovetail into
the dovetail holder on the fork arm. Make sure the bottom of the
dovetail is flat against the dovetail holder. Firmly tighten the hand
bolt to secure the clamp.
1 | ENGLISH
2
To set up the tripod, spread the legs outward until they are fully
extended and push down center leg brace.
5
Snap the hand control holster, with the square tab facing upward,
around any one of the tripod legs.
8
On/Off
Switch
Remove the small plastic tab under the fi nderscope's battery cover
by pulling it straight out. This will allow you to turn the fi nderscope's
red dot on and off. To preserve the fi nderscope's battery life, make
sure you always turn off the red dot when you aren't using it.
S L T T E L E S C O P E
MODEL #22087(90SLT)
Q U I C K S E T U P G U I D E
3
Extend the legs of the tripod by loosening the three hand knobs on
each leg. Pull each leg section all the way out and tighten the hand
knobs down to secure them in place. Use the bubble level on the
tripod head to ensure the tripod is level.
6
Place the motorized fork arm over the top of the tripod head and
tighten the large captive knob between the tripod legs to lock the
mount in place.
9
To attach the fi nderscope, loosen the silver screw and slide
fi nderscope into mounting platform.
ENGLISH