Setting The Time Zone; Figure 3-21. Sntp Configuration - SMC Networks 8124PL2 - annexe 1 Management Manual

Web – Select SNTP, Configuration. Modify any of the required parameters, and click
Apply.
CLI – This example configures the switch to operate as an SNTP unicast client and
then displays the current time and settings.
Console(config)#sntp client
Console(config)#sntp poll 60
Console(config)#sntp server 10.1.0.19 137.82.140.80 128.250.36.2
Console(config)#exit
Console#show sntp
Current time: Jan
Poll interval: 60
Current mode:
SNTP status : Enabled
SNTP server 10.1.0.19 137.82.140.80 128.250.36.2
Current server: 128.250.36.2
Console#

Setting the Time Zone

SNTP uses Coordinated Universal Time (or UTC, formerly Greenwich Mean Time,
or GMT) based on the time at the Earth's prime meridian, zero degrees longitude. To
display a time corresponding to your local time, you must indicate the number of
hours and minutes your time zone is east (before) or west (after) of UTC.
Command Attributes
• Current Time – Displays the current time.
• Name – Assigns a name to the time zone. (Range: 1-29 characters)
• Hours (0-13) – The number of hours before/after UTC.
• Minutes (0-59) – The number of minutes before/after UTC.
• Direction – Configures the time zone to be before (east) or after (west) UTC.

Figure 3-21. SNTP Configuration

6 14:56:05 2004
unicast
Basic Configuration
4-54
4-55
4-54
3-33