Table of Contents
Advertisement
Click Apply Changes to save the settings of this page.
3.7.8.2 UPNP
Click UPNP in the left pane. The page shown in the following figure appears. This page is used to configure UPnP.
The system acts as a daemon after you enable it.
Click Apply Changes to save the settings of this page.
3.7.8.3 Bridge
Click Bridge in the left pane. The page shown in the following figure appears. This page is used to configure the
bridge parameters. In this page, you can change the settings or view some information in the bridge mode and its
attached ports.
48
Advertisement
Table of Contents
