Table of Contents
Advertisement
3.7.4
Routing
Choose Advance > Routing. The page shown in the following figure appears. The page that is displayed contains
Static Route and RIP.
3.7.4.1 Static Route
Click Static Route in the left pane. The page shown in the following figure appears. In this page, you can configure
the routing information. You can add or delete IP routes.
The following table describes the parameters and buttons of this page.
Field
Enable
Destination
Subnet Mask
Next Hop
Metric
Interface
Add Route
Update
Delete Selected
Show Routes
Static Route Table
Click Show Routes. The table shown in the following figure appears. The table shows a list of destination routes
commonly accessed by your network.
Select it to use static IP routes.
Enter the IP address of the destination device.
Enter the subnet mask of the destination device.
Enter the IP address of the next hop in the IP route to the destination device.
The metric cost for the destination.
The interface for the specified route.
Click it to add the new static route to the table.
Select a row in the table to populate the configuration fields with that row's values. Make
any necessary changes to those values and click it to save those changes.
Select a row in the table and click it to delete the row.
Click it, the IP Route Table appears. You can view a list of destination routes commonly
accessed by your network.
A list of the previously configured static IP routes.
Description
42
Advertisement
Table of Contents
