Table of Contents
Advertisement
In the navigation bar, choose LAN. The LAN page that is displayed contains LAN Settings and DHCP Settings.
In this page, you can use the LAN configuration to define an IP address for the router and configure the DHCP
server.
3.4.1
LAN Settings
Choose LAN > LAN Settings. In the LAN Settings page, you can configure the LAN network. In this page, you
can change IP address of the router. The default IP address is 192.168.2.1. This is the private IP address of the
router. This is the address under which the router can be reached in the local network. It can be freely assigned from
the block of available addresses.
The following table describes the parameters and buttons of this page.
Field
IP Address
Subnet Mask
Secondary IP
Apply Changes
3.4.2
DHCP Settings
Choose LAN > DHCP Settings.
Dynamic Host Configuration Protocol (DHCP) allows the individual PC to obain the TCP/IP configuration from
the centralized DHCP server. You can configure this router as a DHCP server or disable it. The DHCP server can
assign IP address, IP default gateway and DNS server to DHCP clients. This router can also act as a surrogate
DHCP server (DHCP proxy) where it relays IP address assignment from an actual real DHCP server to clients. You
can enable or disable DHCP server or DHCP proxy.
Select Disable in the DHCP Server Setup page. The page shown in the following figure appears.
Enter the IP of LAN interface. It is recommended to use an address from a
block that is reserved for private use. This address block is 192.168.2.1-
192.168.2.254.
Enter the subnet mask of LAN interface. The range of subnet mask is from
255.255.0.0-255.255.255.254.
Select it to enable the secondary LAN IP. The two LAN IP address must be in
the different network.
Save the settings of this page.
21
Description
Advertisement
Table of Contents
