Table of Contents
Advertisement
Field
Channel Mode
Admin Status
Enable NAPT
Login Name
Password
Connection Type
Idle Time (min)
WAN IP Settings Type
Local IP Address
Remote IP Address
Subnet Mask
Unnumbered
Default Route
Add
Modify
Delete
Undo
ATM Settings
When the channel mode is set to PPPoE, Click
following figure appears. In this page, you can configure parameters of this PPPoE PVC.
SMC7901BRA4 User Manual
You can choose 1483 Bridged, 1483 MER, PPPoE, PPPoA, or 1483 Routed.
Select Disable, this PVC is unusable.
Select it to enable the NAPT function of the router. If you do not select it and you
want to access the Internet normally, you must add a router on the uplink
equipment. Otherwise, the access to the Internet fails. Normally, it is required to
enable NAPT.
The correct user name that your ISP has provided to you.
The correct password that your ISP has provided to you.
You can choose Continuous, Connect on Demand, or Manual.
If select connect on demand, you need to enter the idle timeout time. Within the
preset minutes, if the router does not detect the flow of the user continuously, the
router automatically disconnects the PPPoE connection.
You can choose Fixed IP or Use DHCP. If select fixed IP, you should enter the
local IP address, remote IP address and subnet mask. If set to use DHCP, the
router is a DHCP client, the WAN IP address is assigned by the remote DHCP
server.
It is the IP address of WAN interface which is provided by your ISP.
This is the gateway IP address which is provided by your ISP.
It is the subnet mask of the local IP address.
Select this checkbox to enable IP Unnumbered function.
Disable or enable the default route.
After configuring the parameters of this page, click it to add a new PVC into the
current ATM VC table.
Select a PVC in the current ATM VC table, then modify the parameters of this
PVC. After finishing, click it to apply the change of this PVC.
Select a PVC in the current ATM VC table, then click it to delete this PVC.
Click it to refresh the page.
Click it, the ATM Settngs page appears. You can configure the parameters of the
ATM for the router, including Qos type, PCR, CDVT, SCR and MBS.
23
Description
in the Current ATM VC Table. The page shown in the
Advertisement
Table of Contents
