Durite 0-441-45 Manual

LED High Intensity Warning
Light Part 0-441-45
WARNINGS
Before using this unit please read these instructions carefully. Take special care to follow the warnings
and safety gestions listed below. Keep these instructions for future reference.
SAFETY WARNING
1. Proper installation of this product requires the installer to have a good understanding of automotive
electronics, sys-tems and procedures.
2. If mounting this product requires drilling holes, the installer MUST be sure that no vehicle compo-
nents or other vital parts could be damaged by the drilling process. Check both sides of the mounting
surface before drilling begins. Also de-burr the holes and remove any metal shards or remnants.
3. Do not install this product or route any wires in the deployment area of your air bag. Equipment
mounted or located in the air bag deployment area will damage or reduce the effectiveness of the air
bag, or become a projectile that could cause serious personal injury or death. Refer to your vehicle own-
er's manual for the air bag deployment area. The User/Installer assumes full responsibility to determine
proper mounting location, based on providing ultimate safety to all passengers inside the vehicle.
4. Do not attempt to activate or control this device in a hazardous driving situation.
5. This product contains either strobe light(s), halogen light(s), high-intensity LEDs or a combination
of these lights. Do not stare directly into these lights. Momentary blindness and/or eye damage could
result.
6. Use only soap and water to clean the outer lens. Use of other chemicals could result in premature lens
cracking (craz-ing) and discoloration. Lenses in this condition have significantly reduced effectiveness.
Inspect and operate this product regularly to confirm its proper operation and mounting condition. Do
not use a pressure washer to clean this product.
7.It is recommended that these instructions be stored in a safe place and referred to when performing
maintenance and/or reinstallation of this product.
8.For this product to operate at optimum efficiency, a good electrical connection to chassis ground must
be made. The recommended procedure requires the product ground wire to be connected directly to the
NEGATIVE (-) battery post.
0-441-45-LEAF
www.durite.co.uk