Opening The Webcockpit Via Ip Address; Changing The Ip Address In The Webcockpit - IDS uEye Live Series Technical Manual

1. Select the camera to change the IP address.
2. Click on "Change IP address".
ð
The dialog for changing the IP address is displayed.
3. Enter a new IP address for the camera. The IP address of the camera has to be in the same subnet as the
network adapter.
4. Enter the subnet mask of the network adapter.
5. Enter the administrator password.
6. Click on "Apply" to change the IP address permanently.
ð
You can now log on to the camera via "Open WebCockpit".
The IP address can be changed subsequently in the WebCockpit if necessary, see section
address in the WebCockpit.

5.3 Opening the WebCockpit via IP address

If a DHCP server is available in the network, the camera uses the IP address that is automatically assigned by
the DHCP server. If no DHCP server is available (timeout), the camera automatically determines a valid IP
address from the reserved link-local address range using the Zeroconf procedure in DHCP mode.
1. Determine the IP address of your camera on the DHCP server or use the link-local address to connect to
the camera. If there is no connection, check the
2. Enter the IP address of your camera directly in the Internet browser.
ð
The WebCockpit of the camera where you

5.4 Changing the IP address in the WebCockpit

After logging in to a camera, you will see the WebCockpit.
1. Select "Camera configuration > Network" in the menu.
January 2025
Fig. 11: Incorrect IP address
status LED of the camera!
set up the camera in the network
uEye Live
uEye SCP: Technical Manual
Changing the IP
opens.
22