Govee Permanent Outdoor Lights 2 (H705D) Manual

What You Get

At a Glance

1. Power Adapter
2. Control Box
3. Permanent Lights
4. Waterproof Connector

Pairing Your Light with Govee Home App

What You Need

• A Wi-Fi router supporting the 2 4GHz and 802.11 b/g/n bands. 5GHz is not supported
• A smartphone or tablet running iOS 8.0 and above Or Android 4.3 and above.
  
  
  

1. Download Govee Home App from the App Store (iOS devices) or Google Play (Android devices)
2. Turn on your smartphone's Bluetooth
3. Open the app, tap the "+" icon in the top right corner and search for "H705D."
4. Tap the device icon and follow the on-screen instructions to complete pairing.

Controlling the Light with Your Voice

1. Open the app, then tap the device icon to enter the details page
2. Tap the settings icon in the top right corner.
3. Select User Guide and follow the on-screen instructions to control the device using your voice

Specifications

Troubleshooting

The light does not work

Part Of the light does not light up

1. Check whether the adapter is working properly A dim green light will appear at the front side of the adapter (close to the output end) when the U.S. standard adapter is in the normal working state.
2. Go to the details page of the light in the app. Tap the settings icon in the upper right corner and adjust in Settings of Number of Segments
3. Make sure you have connected the wire connectors between the string lights
4. Long press the control box for more than 5s to reset the whole light
5. Remove the last string light that lights up. Then, connect each string light that cannot light up with the remaining string lights that can light up properly. Repeat this step until you find the malfunctioning string lights

Cannot connect to Wi-Fi

1. DO not skip the Wi-Fi connection steps in the app.
2. Make sure your home Wi-Fi is 2.4Ghz and your smartphone's Bluetooth is on.
3. Long press the control box for more than 5s to reset the whole light. Unbind and then rebind the light.

4. Connect your smartphone to Wi-Fi and check whether the network works well.
5. Make sure you have entered the correct Wi-Fi name and password
6. If the light is too far away from the Wi-Fi, bring the device closer to the Wi-Fi, and then reconnect to the network
7. Check if there are too many devices connected to the network If so, change to another network.

The adhesive tape is not strong enough

1. Use the clips to secure the light firmly during installation
2. Make sure the installation surface is dust-free, smooth and dry before installation
3. The 3M adhesive will be less sticky after being used once Do not stick repeatedly If you accidentally stick it wrong or the adhesive falls off, replace the adhesive with a new one and try again
4. If the roof surface is rough, it is recommended to use clips with screws for installation.
5. Due to the nature of the adhesive, the initial tack is low at low temperatures. Try to warm up the adhesive as well as the installation location to achieve the best installation result.

App operation guide is needed

1. Open Govee Home App, tap My Govee Instructions>> App Guide>> How to Use to find more details.

For other issues

1. Please contact the Govee support team.

Customer Service