VDO CD 3300 User Instructions page 3

CONNECTOR B for loudspeakers 4 x l (fig. 3)
- Only use loudspeakers that have an impedance of 4 ohms.
- Do not connect any of the loudspeaker wire to earth!
- Do not connect a booster/amplifier directly to the loudspeaker outputs!
- Do not connect loudspeakers via an external fader!
• Blue wire B1: Connect to Rear Right speaker (+).
• Blue/black wire B2: Connect to Rear Right speaker (–).
• Grey wire B3: Connect to Front Right speaker (+).
• Grey/black wire B4: Connect to Front Right speaker (–).
• Green wire B5: Connect to Front Left speaker (+).
• Green/black wire B6: Connect to Front Left speaker (–).
• White wire B7: Connect to Rear Left speaker (+).
• White/black wire B8: Connect to Rear Left speaker (–).
To check the loudspeaker connections keep the SOUND key pressed and switch on the set.
To cancel switch off the set.
OTHER CONNECTIONS
YELLOW CONNECTOR C1 for Line-output (fig. 4)
You can connect a power amplifier with additional loudspeakers to this set:
• Black wire: Connect to Front Left (white) and Front Right (red) channel on amplifier.
• Black wire: Connect to Rear Left (white) and Rear Right (red) channel on amplifier.
• Blue/yellow wire: Connect to Remote on/off on amplifier.
GREEN CONNECTOR C2 (fig. 5)
This gives the following connection possibilities.
TEMPERATURE SENSOR (available separately)
You can connect a temperature sensor to this set to automatically give a visible and audible
warning when the outside temperature becomes lower than 3°C to warn of the possibility of
frost or black ice. The outside temperature can also be shown by pressing the DISPLAY key.
See the mounting instructions for the sensor.
1
Connect the temperature sensor to the connector on the orange wire and activate in
2
'INITIAL SETTINGS', option 'TEMP' and set to 'CELSIUS' or 'FAHRENH'.
See 'TEMPERATURE WARNING' and 'DISPLAY OPTIONS'.
3
This device is an aid only and cannot be used to determine exact road conditions. Use
A
your own judgement at all times to decide whether it is safe to continue driving.
REMOTE CONTROL (available separately)
You can connect a wired remote control to this set.
• Connect the wired remote control to the connector on the black wire.
Please note that you can also use an infrared remote control with this set.
TELEPHONE MUTE
If your car telephone or the car kit of your mobile phone provides a mute signal, it can be used
to automatically interrupt the set's audio output.
• Connect to the yellow telephone mute wire, use the small contact supplied.
Refer to 'INITIAL SETTINGS', options 'PHONE' set to 'MUTE', and then 'PHONE LOW' or 'HIGH'.
4
C