Preparing For Appliance Care; Calling Up The Appliance Care Programme; Running The Basic Appliance Care Programme - Bosch WQB245B0TC User Manual And Installation Instructions

en Appliance care
To change the value, press
‒
or .
To reset the appliance to the
‒
factory settings, press and hold
for approx. 3 seconds.
To exit the basic settings, press 設
4.
定.
Appliance care
16 Appliance care
The appliance offers cleaning pro-
Appliance care
grammes for basic and intensive ap-
pliance care.
16.1 Preparing for appliance
care
Preparing the appliance for the
appliance care programme
Prepare the appliance before running
the appliance care programme.
Requirements
¡ The drum is empty.
¡ The appliance is in standby mode.
Clean the fluff filter → Page 30.
1.
Pull out the condensation con-
2.
tainer horizontally and empty it.
→ Page 32
Preparing the condensation
container for the appliance care
programme
If you drain the condensation from
the appliance using the drain hose,
prepare the condensation container
before running the appliance care
programme.
38
Remove the stopper from the re-
1.
cess in the top
the underside
Clean the filter in the condensation
2.
container.
16.2 Calling up the appliance
care programme
Requirement: The appliance care
programme is ready. → Page 38
Press .
1.
The switch-on process takes a few
seconds.
Press 設定.
2.
Set the programme to position 5.
3.
a "CP1" and the programme duration
alternate on the display.
16.3 Running the basic appli-
ance care programme
To remove light dirt deposits in the
appliance, you can run the basic ap-
pliance care programme.
Notes
¡ The basic appliance care pro-
gramme runs for approximately
1 hour.
and insert it in
⁠ .