Haier HDW10F1S1 User Manual page 33

Error codes on the display
Problem
Acoustic alarm,
LED flash at interval
(1 time / 1 sec).
The alarm code is
E10.
The appliance does
not fill with water.
Acoustic alarm,
LED flash at interval
(3 times / 1 sec)
The alarm code is
E30.
Leak: The drain
pump
runs permanently!
All other Alarmcodes:
1. Note Alarmcode
2. Contact Service ; refer to CUSTOMER SERVICE
Possible cause
Water tap is closed.
Water inlet hose has a kink or
a bend.
In case of aqua-stop system:
water protection is triggered;
the marker (C) is red.
Filter in the water inlet hose
is clogged.
Water inlet is clogged.
Water pressure is too low.
Anti- flood device is on:
There are water leakages in
the appliance.
The water inlet valve is
open and blocked.
The drainage is blocked.
Troubleshooting
Possible solution
Open the water tap.
Note: Whenever Error is
solved switch off the
appliance and restart the
programm.
Make sure that the position of
the hose is correct.
The hose must be replaced.
Clean the filter at the inlet
hose connections at tap and
the rear of the appliance.
Check water flow from tap.
Contact your local water
authority.
1.Close the water tap.
2.Disconnect appliance from
power supply.
3.Contact Service.
31