Summary of Contents for MartinLogan Dynamo Foundation 10
Page 4
• To prevent fire or shock hazard, do not expose To find your local distributor please contact the dealer from whom this module to moisture. you purchased this product, email info@martinlogan.com or visit the • Turn subwoofer off should any abnormal conditions occur. distributor locator at www.martinlogan.com.
Page 7
∙ Power Cord ∙ Subwoofer *Subwoofer cable not included...
Page 8
onTrols Low-Pass Filter The Low Pass Filter lets you adjust the low-pass frequency for the left and right inputs. The Low-Pass filter value sets the point where the subwoofer will begin to “roll off” or gradually reduce its output. You do not want your subwoofer playing sounds that are too high in frequency, nor do you want to give your subwoofer too little content to play.
Page 9
Phase continued If you are using the subwoofer to augment other M ar tinLogan produc ts, we sugges t star tting with the phase set at 0°. In a system where phase and polarity are properly set, the main speakers and subwoofer should work together and sound as if there is more total bass in the system.
Page 10
Udio ignal onneCTions Line Level Input (Left In / Right In) Connect from the Main Out/Pre Out/Sub Out on your receiver/pre-amp/electronic device. The setting for the Low-Pass Filter control is applied to the signal received through these inputs unless the Low-Pass filter control is set to Bypass. The Left and Right inputs will be summed internally, so the subwoofer will play content from the Left input, Right input or both simultaneously.
Page 11
laCemenT Placement As a starting point, we recommend placing the subwoofer in one of the shaded areas below. The corners will typically yield the highest output, while the front wall near the speakers typically provides the most seamless blend with the main speakers. When using multiple subwoofers try to place them in opposite corners or opposite walls in order to help spread the bass into the room more evenly.
Page 12
• Check that all system components are turned on • If you are unable to resolve your problem, and source material is playing. please contact your dealer or MartinLogan cus- • Check speaker wires and connections. tomer service (see below).
Page 13
SERVICE Should you use your MartinLogan product in a country other than the one in which it was originally purchased, we ask that you note the following: 1. The appointed MartinLogan distributor for any given country is responsible for warranty servicing only on units distributed by or through it in that country in accordance with its applicable warranty.
Page 14
® PeCifiCaTions Foundation 10 Subwoofer Frequency Response . . . . . . . . . . . . . . . . . . . . . 25Hz-200Hz (in bypass mode) Low Frequency Driver .
Need help?
Do you have a question about the Dynamo Foundation 10 and is the answer not in the manual?
Questions and answers