Aqua Control SP10 Installation & Owner's Manual page 2

INITIAL INSPECTION
UPON RECEIVING YOUR ORDER – OPEN AND INSPECT PRODUCT IMMEDIATELY
Product damaged in delivery
The Aqua Control Inc., (ACI) aeration system was properly packed and accepted by the
freight carrier for shipment. It is therefore their responsibility to deliver the system in perfect
condition.
Apparent damage or loss
If upon delivery the equipment or containers indicate DAMAGE IN TRANSIT, such goods
should be refused or not accepted until the transportation company's agent has noted such on
the freight bill. A copy of such bill will be given to you, noting the nature and extent of the
damage. If any part of shipment is LOST IN TRANSIT, have shortage noted on freight bill by
agent.
Concealed damage
If damage is discovered, that was not apparent upon delivery, notify the transportation
company immediately to inspect damaged equipment. The inspector will be required to
provide a "CONCEALED BAD ORDER" report. Inspections must be requested within 15 days
of delivery. Do not move damaged goods from original point of delivery. Retain all original
packing/containers for inspection. File a "FULL VALUE REPLACEMENT" claim against the
transportation company."
Product warranty
ACI will repair or replace any defective part for a period of three years from date of receipt.
Customer is responsible for return shipping of any goods for warranty inspection by ACI. After
inspection, if product shows manufacturing defect, ACI will replace or repair it at no cost to
customer. Should inspection indicate non-warranty failure (incorrect voltage, faulty installation
procedures, vandalism, customer negligence, etc.) warranty would be void.
SYSTEMS MATERIAL LIST
Upon receipt, inspect to ensure that all of the components are included. If your aeration
system has experienced damage from shipping, promptly report the damage to the carrier
that provided delivery. Verify that you have received the following equipment.
o Compressor
o Stainless Steel Diffuser Base(s)
o Self-Weighted Air Supply Tubing (Purchased separately for model SP30 and
SP40)
o 3/8 Hose barbs come preinstalled in manifold and diffusers for Model SP10
and SP20
o 3/8 and 5/8 Hose barbs wrapped with thread seal tape for Model SP30 and
SP40 only.
o Blue check valve assembly
o Hose clamps
o Manifold assembly (Not included in model SP10)
2