Turn On Your Headset; Pair It With Your Phone; Wear It How You Like It; How To - Jabra BT500 User Manual

2

Turn on your headset

• Press the answer/end button to turn on your headset.
• Press and hold the answer/end button to turn off your headset.
3

Pair it with your phone

Before you use your Jabra BT500, you need to pair it with your mobile
phone.
1. Put the headset in pairing mode
•
Make sure the headset is on.
• Press the pairing button marked
2. Set your Bluetooth phone to 'discover' the Jabra BT500
Follow your phone's instruction guide. This usually involves going to a
'setup, ' 'connect' or 'Bluetooth' menu on your phone and selecting the
option to 'discover' or 'add' a Bluetooth device.* (See example from a
typical mobile phone in fig. 5. )
3. Your phone will find the Jabra BT500
Your phone then asks if you want to pair with it. Accept by pressing 'Yes'
or 'OK' on the phone and confirm with the passkey or PIN = 0000 (4 zeros).
Your phone will confirm when pairing is complete. In case of
unsuccessful pairing, repeat steps 1 to 3.
4

Wear it how you like it

The Jabra BT500 is ready to wear on your right ear. If you prefer the left,
gently rotate the MiniGel™ ear piece 180°. See fig. 1.
For optimal performance, wear the Jabra BT500 and your mobile phone
on the same side of your body or within line of sight. In general, you will
get better performance when there are no obstructions between your
headset and your mobile phone.
5

How to...

Answer a call
• Tap the answer/end button on your headset to answer a call.
End a call
• Tap the answer/end button to end an active call.
4
.
Reject a call*
• Press the answer/end button when the phone rings to reject an
incoming call. Depending on your phone settings, the person who called
you will either be forwarded to your voice mail or hear a busy signal.
Make a call
• When you make a call from your mobile phone, the call will (subject to
phone settings) automatically transfer to your headset.
Activate voice dialing*
• Tap the answer/end button. For best results, record the voice-dialing tag
through your headset. Please consult your phone's user manual for more
information about using this feature.
Redial last number*
• Press the answer/end button.
Call waiting and placing a call on hold*
This lets you put a call on hold during a conversation and answer a waiting call.
• Press the answer/end button once to put the active call on hold and
answer the waiting call.
• Press the answer/end button to switch between the two calls.
• Tap the answer/end button to end the active conversation.
Adjust sound and volume*
• Press the volume up or down (+ or -) to adjust the volume. Show fig. 1.
• To mute, press both volume up and down at the same time. A low beep
alert plays during a muted call.
• To un-mute, tap either of the volume buttons.
*Dependent on your phone supporting this feature
6

What the lights mean

What you see What this means
Flashing blue light Flashing every second: active on a call
Flashing blue light Flashing every three seconds: in standby mode
Flashing red light Running low on battery
Solid red light Charging
Solid green light Fully charged
Solid blue light In pairing mode – see section 3
5