M7 DOM-101 Manual page 7

or sold by the battery-charger
manufacturer may result in a risk of fire,
electric shock or injury to persons.
4. Do not abuse the cord or charger. Never
use the cord to carry the charger. Do not
pull the charger cord to disconnect the
plug from receptacle. Damage to the cord
or charger could occur and create an
electric shock hazard. Replace damaged
cords immediately.
5. Make sure that the cord is located so
that it will not be stepped on, tripped
over, come in contact with sharp edges
or moving parts, or otherwise subjected
to damage or stress. This will reduce the
risk of accidental falls, which could cause
injury and damage to the cord, which
could then result in electric shock.
6. Keep cord and charger from heat to
prevent damage to housing or internal
parts.
7. Do not allow gasoline, oils, petroleum-
based products, etc. to come in contact
with plastic parts. These materials contain
chemicals that can damage, weaken, or
destroy plastic.
8. An extension cord should not be used
unless absolutely necessary. Use of an
improper extension cord could result
in a risk of fire and electric shock. If an
extension cord must be used, make sure
that:
The pins on plug of extension cord are the
same number, size and shape as those of
the plug on charger.
The cord is properly wired and in good
electrical condition
The size is large enough for AC ampere
rating of charger as specified below:
The Cord Length (Feet) 25' 50' 100'
Cord Size (AWG) 16
NOTE: AWG = American Wire Gauge
The serial number of Mighty Seven would have year in 2nd/3rd digital number and months
showed by 4th/5th digital number.
GENERAL INFORMATION
9. Do not operate the charger with a
damaged cord or plug, which could cause
shorting and electric shock. If damaged,
have the charger repaired or replaced by
an authorized service technician at m7
Service Center.
10. Do not operate the charger if it has
received a sharp blow, been dropped,
or has otherwise been damaged in any
way. Take it to an authorized service
technician at m7 Service Center for
an electrical check to determine if the
charger is in good working order.
11. Do not disassemble the charger. Take
it to an authorized service technician at
a m7 Service Center when service or
repair is required. Incorrect reassembly
may result in a risk of electric shock or
fire.
12. Unplug the charger from the
electrical outlet before attempting any
maintenance or cleaning to reduce the
risk of electric shock.
13. Disconnect charger from the power
supply when not in use. This will reduce
the risk of electric shock or damage to
the charger if metal items should fall
into the opening. It will also help prevent
damage to the charger during a power
surge.
14. Risk of electric shock. Do not touch the
uninsulated portion of output connector
or uninsulated battery terminal.
15. Save these instructions. Refer to them
frequently and use them to instruct
others who may use this tool. If you
lend this tool to someone else, also lend
these instructions to them to prevent
misuse of the product and possible
injury.
7