Download Print this page

Discount Car Stereo BTH-STS Installation Manual

Quick start bluetooth module for 2005-11 cadillcac sts with xm module(u2k)

Advertisement

Quick Links

Courtesy of: DiscountCarStereo.com
Serving the internet community since 1995
BTH-STS
QUICK START BLUETOOTH MODULE INSTALLATION GUIDE FOR 2005-11 CADILLCAC STS WITH XM MODULE (U2K)
Created November 19, 2019
Revised: November 6, 2024

Advertisement

loading
Need help?

Need help?

Do you have a question about the BTH-STS and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Discount Car Stereo BTH-STS

  • Page 1 Courtesy of: DiscountCarStereo.com Serving the internet community since 1995 BTH-STS QUICK START BLUETOOTH MODULE INSTALLATION GUIDE FOR 2005-11 CADILLCAC STS WITH XM MODULE (U2K) Created November 19, 2019 Revised: November 6, 2024...
  • Page 2 PRODUCT SAFETY & DISCLAIMER Installation READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE Radio removal required to gain access to the connectors. PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY • This document is provided as a GENERAL installation guide, some vehicles vary and may Using a panel removal tool, unclip and remove the top A/C vents panel require additional steps.
  • Page 3 Fig. 3 Radio 16-pin connector Fig. 5 Disconnect factory XM 16-pin (See Fig. 4) from radio (See Fig. 3). To 16-pin connector disconnect, pull BLUE locking tab, press and hold BLACK tab, grasp and Connect installation harness 16-pin plug to radio chamber vacated in pull to release plug from radio.
  • Page 4 Optional: Drill a 15/64 or 1/4” hole in dash or panel, push aux jack shaft through and secure with nut (See Fig. 10) Fig. 7 Locate 12V accessory at vehicles cigar lighter, fuse box, ignition cluster etc.) Warning: Fig. 10 Extension (Fig.
  • Page 5 Optional USB extension cable installation Note: 1. Optional USB dash mount extension cable is not required for operation, however it extends USB charging port (See Fig. 17) to dashboard, glovebox etc. The USB port supports software updates and charging only Drill a ¾”...
  • Page 6 Pairing Pairing process varies among devices but the basic steps are the same. This process is done upon initial install and will not have to be repeated. Turn ignition and radio “ON” 2. From your Bluetooth enabled device, turn the Bluetooth ON and search for Bluetooth devices.
  • Page 7 YES; as long as XM module remain in vehicle. 4. My XM subscription is active. Will it be lost after installing the BTH-STS? NO, this module retains XM subscription. Select “Subscribed”. If subscription has expired; an AUX input jack is provided.
  • Page 8 Fig. 23 © 1995-Nov-24 Discount Car Stereo, Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders.