Connection of your receiver:
1. Unplug your motor.
2. Check that your receiver is supplied with a 12V or 24V power supply
Check that your receiver is supplied with a 12V or 24V power supply. If the voltage delivered
by the circuit board of your motor is greater (for example, 220V), you will have to install a
by the circuit board of your motor is greater (for example, 220V), you will have to install
by the circuit board of your motor is greater (for example, 220V), you will have to install
transformer.
3. Make the following connections with the electric
Make the following connections with the electrical wires as indicated in the diagram above
-
Connect channel 1 between terminals 5 and 7 on the receiver (you have to insert the
Connect channel 1 between
wire in the hole under the screws and then screw them to lock th
wire in the hole under the screws and then screw them to lock the wire)
-
Connect channel 2 between terminals 6 and 8 on the receiver.
Connect channel 2 between
-
The terminals 9 to 16 are specific to the remote control MR4E
The terminals 9 to 16 are specific to the remote control MR4E
-
Connect the terminal + of the motor (or terminal with a tension indication) to
Connect the terminal + of the motor (or terminal with a tension indication) to
Connect the terminal + of the motor (or terminal with a tension indication) to terminal 1
on the receiver
-
Connect the terminal – or GMD of the motor to terminal 3 on the receiver
Connect the termina
4. Your receiver is connected.
Your receiver is connected.
http://www.remotecontrol-express.com
Programming Manual
PRASTEL MR2E – MR4E
express.com
- TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151
If the voltage delivered
al wires as indicated in the diagram above:
the receiver (you have to insert the
e wire)
the receiver
+44 (0) 207 927 3151
Need help?
Do you have a question about the MR2E and is the answer not in the manual?
Questions and answers