Page 2
Children of less than 3 years should be kept away unless • continuously supervised. General Safety The appliance and its accessible parts become hot during use. • Do not touch the heating elements. Do not operate the appliance by means of an external timer or • separate remote-control system. www.zanussi.com...
Page 3
• All electrical connections should be made by • Seal the cut surfaces with a sealant to a qualified electrician. prevent moisture to cause swelling. • The appliance must be earthed. • Protect the bottom of the appliance from steam and moisture. www.zanussi.com...
Page 4
• Before installation, make sure that the local WARNING! distribution conditions (nature of the gas and Risk of damage to the appliance. gas pressure) and the adjustment of the • Do not keep hot cookware on the control appliance are compatible. panel. www.zanussi.com...
Page 5
• Do not let acid liquids, for example vinegar, • Use original spare parts only. lemon juice or limescale remover, touch the hob. This can cause matt patches. Product description Cooking surface layout Rapid burner Semi-rapid burner Auxiliary burner Control knobs www.zanussi.com...
Page 6
The again after minimum 1 minute. manufacturer declines any responsibility in case of the flame The spark generator can start misuse. automatically when you switch on the mains, after installation or a power cut. It is normal. www.zanussi.com...
Page 7
• Wash stainless steel parts with water, and then dry them with a soft cloth. 2. The enamel coating occasionally can have rough edges, so be careful when you wash the pan supports by hand and dry them. If www.zanussi.com...
Page 8
The instructions yourself, contact your dealer or an Authorised about the Service Centre and conditions of Service Centre. Give the data from the rating guarantee are in the guarantee booklet. plate. Make sure, you operated the hob www.zanussi.com...
Page 9
For appliances installed in the Republic of same room, B.S. 5440 Part 2 Current Edition, Ireland please refer to NSAI- Domestic Gas should be consulted to determine the requisite Installation I.S. 813 Current Editions and the air vent requirements. ETCI Rules for Electrical Installations. www.zanussi.com...
Page 10
A) End of shaft with nut different from the necessary pressure, you must B) Washer fit an applicable pressure adjuster on the gas C) Elbow supply pipe. Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or copper. www.zanussi.com...
Page 11
(e.g. your local Electricity D) Cord clamp Board, or a contractor who is on the roll of the E) Blue National Inspection Council for Electrical The wires in the cord are coloured as follows: Installation Contracting [NICEIC]). www.zanussi.com...
Page 12
'L'. It must always be connected to the network phase. There must be no cut or stray strands of wire present. The cord clamp must be correctly attached to the outer sheath. A) Removable panel B) Space for connections www.zanussi.com...
Page 13
3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse Appliance category: II2H3+ Gas connection: R 1/2" Appliance class: Gas burners for NATURAL GAS G20 20 mbar BURNER NORMAL POWER kW MINIMUM POWER kW INJECTOR MARK 1/100 mm Rapid 0,75 Semi-rapid 0,45 Auxiliary 0,33 www.zanussi.com...
Page 14
Return the product to your the packaging in applicable containers to local recycling facility or contact your municipal recycle it. Help protect the environment and office. human health and to recycle waste of electrical and electronic appliances. Do not dispose www.zanussi.com...
Need help?
Do you have a question about the ZGG62444 and is the answer not in the manual?
Questions and answers