Download
Share
Print this page
  1. Manuals
  2. Brands
  3. weintek Manuals
  4. Control Unit
  5. M02
  6. User manual

weintek M02 User Manual

Wifi expansion module
Hide thumbs Also See for M02:
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
User
Manual
M02 Startup Guide

Advertisement

loading
Need help?

Need help?

Do you have a question about the M02 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for weintek M02

Summary of Contents for weintek M02

  • Page 1 User Manual M02 Startup Guide...
  • Page 2 Table of Contents Chapter 1 Overview ............................. 1 Specification ............................1 Dimensions ............................2 Installation ............................3 Chapter 2 Wi-Fi Settings ............................4 Set in internet browser ........................4 Set on HMI............................5...
  • Page 3 Altitude (Air Pressure) Below 3,000 meters (70.1kPa) Vibration Endurance 10 to 25Hz (X, Y, Z direction 2G 30 minutes) CE marked Certificate cULus Listed V6.05.02 or later versions Software EasyBuilder Pro UM021003E_20241220 Copyright© 2024 WEINTEK IIOT LTD.. All rights reserved.
  • Page 4 2000mm [78.74"] 24.1mm [0.95"] 54.5mm [ 54.5mm [2.15"] SMA Male Connector RG174 Black Coaxial Cable 侧视图 正视 Side View Side View Foam Sticker 底视 Antenna SMA Female Connector Male Connector to HMI UM021003E_20241220 Copyright© 2024 WEINTEK IIOT LTD. All rights reserved.
  • Page 5 M02 Startup Guide 1.3 Installation M02 does not support hot swapping by design. Please connect it to HMI before powering up HMI. UM021003E_20241220 Copyright© 2024 WEINTEK IIOT LTD. All rights reserved.
  • Page 6 M02 Startup Guide Chapter 2 Wi-Fi Settings Connect M02 to HMI and then start up HMI. Log in system settings in one of the following two ways and configure Wi-Fi parameters. 2.1 Set in internet browser Connect HMI with PC using an Ethernet cable, open internet browser (IE, Chrome, or Firefox), and enter HMI’s IP address (e.g.: 192.168.2.177) to configure HMI settings.
  • Page 7 HMI to access the relevant settings for the HMI. At the bottom of the Network page, WiFi Connection settings can be found. WiFi: Select Wi-Fi AP and define the encryption type. UM021003E_20241220 Copyright© 2024 WEINTEK IIOT LTD. All rights reserved.
  • Page 8 A Wi-Fi hotspot’s connection can be shared with up to 10 client devices at a time. Other company names, product names, or trademarks in this document are the trademarks or registered trademarks of their respective companies. This document is subject to change without prior notice. UM021003E_20241220 Copyright© 2024 WEINTEK IIOT LTD. All rights reserved.