DAHON - SERVICE INSTRUCTIONS 2010 Service Instructions Manual page 11

Position Stem for Unfolding
Tools Needed:
• 5 mm Allen Key
Step 1 - Loosen the angle
adjustment bolt in the middle of the
stem with a 5 mm Allen key.
Step 5 – Lift the stem off the
handlepost, turn it by 90°, and put
it back onto the handlepost, so
that the handlebar is in the proper
riding position.
Step 2 – Adjust the handlebar
upwards.
Step 6 - Retighten the height
adjustment bolt at the back of
the stem with a 5 mm Allen key.
Tighten it to a torque of 10 Nm..
Step 3– Retighten the angle
adjustment bolt. Tighten it to a
torque of 10 Nm.
Handlebar and front wheel should
now be perpendicular to each
other.
© 2009 DAHON, BPSA • 2009.09.DS.EN
Step 4 - Loosen the height
adjustment bolt at the back of the
stem with a 5 mm Allen key.
11