DAHON - SERVICE INSTRUCTIONS 2010 Service Instructions Manual page 25

Version B
Tools Needed: • 6 mm Allen key • 2.5 mm Allen key
NOTE: Only turn the adjustment bolt in small increments (e.g. a 1/8
turn) each time otherwise you might over tighten or over loosen it.
Do not over tighten the adjustment bolt. Over tightening the
adjustment bolt will cause damage to the meshing mechanism, which
will eventually affect the functionality of the LockJaw and your safety.
Do not over loosen the adjustment bolt. If it is too loose, the
LockJaw hinge will not close tightly, which will result in a loose joint.
First open the OC Bolt
(turn 180º counter-clockwise)
NOTE: Before you can adjust the adjustment bolt, you must loosen
and remove the safety screw first.
2.5 mm
Allen key
Loosen the safety screw by
turning it counter-clockwise
But DO NOT open the frame
Then remove the safety screw
Adjust the Adjustment Bolt while the frame is closed.
TIGHTEN
To tighten the adjustment bolt,
turn it as indicated by the arrow
(clockwise when looking at the bolt
head-on)
OPEN
To check the correct tightness of the LockJaw close and open the OC
bolt. When the OC bolt closes with a "click" at the end, the tightness is
just right.
Once you have achieved the
correct tightness, insert and
tighten the safety screw.
© 2009 DAHON, BPSA • 2009.09.DS.EN
LOOSEN
To loosen the adjustment bolt,
turn it as indicated by the arrow
(counter-clockwise when looking at
the bolt head-on)
CLOSE
25