Override Functions - Plantronics CA40 DECT User Manual

OVERRIDE FUNCTIONS

UK
WARNING: The following master reset and overides should only be invoked if you have
failed to achieve satisfactory product performance having followed the troubleshooting
hints and tips provided in the Troubleshooting Section (see page 12). It is strongly
advised you contact either your supplier or Plantronics Customer Helpline (see back
page) before attempting these functions.
MASTER RESET
This reset will cause all CA40 Adapter settings to revert to their original factory default values.
To perform a reset:
1. Press and hold the Page Button (8), then press the Headset Button (2) and Mode Button (5) and
hold all three buttons until all the base unit indicator lights start blinking. This will take
approximately 3 seconds.
2. The reset is then complete, the factory default settings reinstated and the CA40 Adapter will
revert to it's normal power-up state. Wait 5 seconds before operating the CA40. If this
operation is performed in Headset mode during a call you may lose the call.
TRANSMIT OVERRIDE
1. Ensure the system is in Headset mode.
2. Press and hold the Page Button (8), press the Mode Button (5), then release both buttons.
The Speak Volume Indicator (6) blinks.
3. Press the Up (3) or Down (4) button to adjust the Speak Volume range.
4. Press the Mode button (5) or wait 10 seconds to save the new setting and exit.
RECEIVE OVERRIDE
1. Ensure the system is in Headset mode.
2. Press and hold the Page Button (8), press the Mode Button (5) twice, then release both buttons.
The Tone Indicator (7) blinks.
3. Press the Up (3) or Down (4) button to adjust the receive level.
4. Press the Mode Button (5) or wait 10 seconds to save the new setting and exit.
16