Source Setup (Table View); Ipod Setup - NAD M15 HD Owner's Manual

A/V PRESET
A particular Source can be assigned a stored Preset. The parameters set up
in the selected Preset number will be adopted into the particular Source it
is assigned (Please refer to the separate section on 'A/V Presets' for further
understanding of Preset settings).
Scrolling to 'A/V Preset' and by pressing
could be assigned a Preset number ranging from Preset 1 to 5.
If it is desired not to assign the particular Source a Preset setting, select
'None' .
TRIGGER OUT
The Trigger Out for a particular Source is dependent on the configurations done in
a separate menu on Trigger Setup (See 'Trigger Setup' below). If all three available
Trigger outputs are assigned to 'Source Setup' in the separate 'Trigger Setup' window,
a particular Source can have the following Trigger Out combinations
Trigger Out ➜ 1 ➜ 2 ➜ 1 + 2 ➜ 3 ➜ 1 + 3 ➜ 2 + 3 ➜ 1+2+ 3
These combinations are dependent on the assignment of 'Source Setup' for
'Trigger 1 Out, Trigger 2 Out or Trigger 3 Out' at the Trigger Setup menu.
Another option is 'None' whereby the particular Source is not assigned any
Trigger Out.
For 'Trigger Out' to become enabled and assignable at 'Source Setup
(Normal View)' menu, make sure to carry out or note the following
beforehand
• In the separate 'Trigger Setup' menu, assign 'Trigger 1 Out, Trigger 2 Out
or Trigger 3 Out' to 'Source Setup. '
• 'Trigger Out' will not appear as an option at the Source Setup (Normal
View) menu if at the separate 'Trigger Setup' menu, 'Trigger 1 Out,
Trigger 2 Out or Trigger 3 Out' are all assigned to 'Main, Zone 2, Zone
3, Zone 4, Zone 2+3+4, Main + Zone 2, Main + Zone 3, Main + Zone 4
or Main + Zone 234'; with not even one 'Trigger Out' port allocated to
'Source Setup. '
and then keys, a Source
USING THE M15 HD – SETUP MENU

SOURCE SETUP (TABLE VIEW)

The Source Setup (Table View) reflects the settings made in the Source
Setup (Normal View) menu. All the Source settings are summarized and
displayed in tabulated form in the Source Setup (Table View).
Navigating through the Source Setup (Table View) via a combination of
and then keys, one will have the benefit of directly changing the
settings for 'Audio, Video, Preset, Trigger and Source Name' without going
back to the Source Setup (Normal View) menu.

iPod SETUP

The iPod Setup menu allows you to preset the following associated settings
when iPod is the selected source:
Enabled : Select 'Yes' to enable iPod as a Source or 'No' to disable it.
Auto Connect : Select 'Yes' to automatically enable and connect the
iPod player docked in the linked NAD iPod docking station when
Source 4 (the default iPod source allocation in the M15 HD) is selected.
Select 'No' if you do not want for the iPod connection automatically
connected.
Menu Timeout : Set the time for the OSD to revert to the 'Now
Playing' display when the iPod menu has been left idle (no scrolling or
navigation being done) for the specified time out time. For the 'Now
Playing' OSD to be shown, there should be a song paused or being
played before going to the iPod menu. You can set the 'Menu Timeout'
between the range 5s to 60s at 5s increments. If you do not want for
the menu to timeout, select 'Off. '
OPERATION
1