Table of Contents
Advertisement
1
1 phoneS: Accepts stereo headphone using a standard 1/8-inch stereo
phone plug. Plugging in your headphone automatically mutes output
from the speakers and subwoofer output (but not from the VCR OUT
jacks of the VCR). The VFD will show "H/P ON" when you headphone is
plugged in to this jack and "H/P OUT" when unplugged.
2 StandbY led: This indicator will light up amber when the C 717
is in standby state. When the C 717 is at ON state, this indicator will
illuminate blue. This indicator will extinguish itself when the power
cable is unplugged from the AC supply.
3 StandbY: Press this button to switch ON the C 717. The Standby
LED indicator will turn from amber to blue and illuminate the Vacuum
Fluorescent Display (VFD). Pressing the Standby button again turns
the unit back to standby mode. It is usual (and perfectly acceptable)
to leave the C 717 in standby mode in between normal viewing and
listening sessions.
The C 717 can also be switched ON from standby mode by pressing
[OPEN/CLOSE] or [PLAY/PAUSE] buttons on the front panel as well as on
the remote control.
If the disc tray is open and the Standby button is pressed, the disc tray
will draw close and the C 717 goes to standby mode.
Note that when you do choose to switch off to standby mode using the
front panel Standby button, the C 717's memory back-up system will
store tuner preset and other settings for several weeks while the unit is
switched off.
4 Source: Toggle to select desired Source as follows
Internal DVD
Internal FM tuner
then back to Internal DVD.
Refer also to the item about SELECTING SOURCES under the SETTING
UP THE C 717 section of the SETUP page.
14
15
2
3
4
5
6
7
Internal AM tuner
TV
VCR
IDENTIFICATION OF CONTROLS
8
9
10
11
12
13
5 diSc traY: With the DISC TRAY open, insert a DVD, CD or other
compatible media disc face down onto the tray. If the disc is placed
upside down and it is a single sided disc or there is no disc loaded, "NO
DISC" appears on both the C 717's VFD and the TV/Monitor screen.
6 open/cloSe: Press this button to open and close the disc tray and
simultaneously select the internal DVD player. When in standby mode,
this button will also power ON the C 717 and at the same time open the
disc tray.
7 plaY/pauSe: This dual-function button alternates between starting
and stopping playback. Press this button to toggle between Play and
Pause of a DVD, CD or other compatible media disc. Press to start play
or resume play after Pause. If the disc tray is open, press this button to
automatically close the tray and start playback if a disc is loaded.
During playback, press this button to stop playback temporarily,
keeping the optical pickup at its current position on the disc. To resume
playback at the exact point where it stopped, press [PLAY/PAUSE] again.
8 Stop: During playback, press this button to stop and at the same time
pause playback of disc – "PRESS PLAY TO CONTINUE" or "STOP" will be
briefly displayed in the OSD and "RESUME" in the VFD. If [STOP] button is
pressed consecutively during playback, disc playback will fully stop.
9 timer: In combination with the [SCROLL/PUSH/ENTER] knob, toggle
this button to cycle through the following timer modes:
Time
Timer
SLEEP
Refer also to OPERATION - SETTING UP THE TIMER page.
front panel
7
Advertisement
Table of Contents
