Adjusting Tone And Balance Controls; Factory Default Settings - NAD C717 Owner's Manual

ADJUSTING TONE AND BALANCE CONTROLS

Toggle the [TONE/BALANCE] button to step through the following modes
- "BASS", "TREBLE" or "BALANCE CENTER". Select the feature you want to
adjust and within 3 seconds, turn [SCROLL/PUSH/ENTER] clockwise or
counterclockwise to change the level settings.
baSS and treble
Treble and bass controls only affect the low bass and high treble leaving the
critical midrange frequencies free of coloration. Maximum and minimum
values for both Tone Control levels are ±10dB.
balance
The BALANCE control adjusts the relative levels of the left and right
speakers. The BALANCE CENTER position provides equal level to the left and
right channels. BALANCE can be adjusted to the following levels - "BALANCE
R+1" up to "BALANCE R or "BALANCE L+1" up to "BALANCE L +6".

FACTORY DEFAULT SETTINGS

Sometimes power spikes and drop-outs may from time to time cause some
inadvertent functionality. The procedure below will set the C 717 to factory
default settings
1 Turn OFF C 717 by pressing the STANDBY button in the front panel or
SR 9 remote control's [OFF] key.
2 Press and hold front panel's [TUNER MODE], [SOURCE] and STANDBY
buttons for more than two seconds. The C 717 will switch itself back
ON. "SERVICE MODE" will be shown in the upper line of the VFD and
below it are details about the current software program.
3 Press and hold [TUNER MODE] button and release it as soon as the VFD
blinks. The C 717 will switch itself to standby mode. The C 717 is now
restored to its factory default settings.
Please note that setting the C 717 to factory default will delete all AM and
FM presets. The timer settings will also be restarted.
SETUP
Setting up the c 717
1