Identification Of Controls; Front Panel - NAD T 777 Owner's Manual

IDENTIFICATION OF CONTROLS

FRONT PANEL

1 2 3
AV Surround Sound Receiver T 777
d
a s
f
10
1 STANDBY BUTTON
Press this button to switch ON the T 777 from standby mode. The
Standby LED indicator will turn from amber to blue and illuminate
the VFD. Pressing the STANDBY button again turns the unit back to
standby mode.
The T 777 can also be switched ON from standby mode by pressing
any of the front panel buttons.
NOTE
In order to turn ON the T 777 from standby mode or back to standby
mode, the rear panel POWER switch must be in the ON position.
2 STANDBY LED
This indicator will light up amber when the T 777 is at standby
mode.
When T 777 is powered up from standby mode, this indicator will
illuminate blue.
If a Zone (Zone 2, Zone 3 or Zone 4) is ON and STANDBY button
is pressed to switch the T 777 to standby mode, the VFD will be
extinguished but the STANDBY LED remains illuminated blue.
This indicates a Zone (Zone 2, Zone 3 or Zone 4) is still active. The
corresponding active Zone icon(s) will also remain displayed in the
VFD.
In order to completely shut down the T 777 with Zone 2, Zone 3
and/or Zone 4 still ON, press and hold STANDBY button until the
STANDBY LED turns amber.
When infrared command from the HTR 8 is received, this indicator
will also flash momentarily.
3 NAVIGATION and ENTER BUTTONS
The navigation ([d/f/a/s]) and [ENTER] buttons have various
applications specific to given modes. The middle round button is
designated as [ENTER] button; this is normally pressed to complete a
selection, procedure, sequence or other applicable functions.
6
4 5
NAD T777
MEMORY INFO
DELETE
A SPEAKERS B AM/FM/DB TUNER MODE LISTEN MODE
11 12 13 14
6 7
a SOURCE
TONE TONE DEFEAT FRONT INPUT/MP
A
15 16 17
AM/FM mode
Toggle [ENTER] button to switch between "Tune" and "Preset" mode.
Select "Tune" mode.
Pressing momentarily the [a/s] button will manually scan the AM
or FM band.
Press and hold [a/s] for more than 2 seconds to search up or down;
the T 777's tuner will stop at the next sufficiently strong signal it
encounters.
· Note that this function "wraps" - that is, it will continue to search
from one end of the AM or FM band to the other until it stops at a
strong signal.
Toggle [ENTER] button to switch between "Tune" and "Preset" mode.
Select "Preset" mode.
d/f] to step up or down AM/FM Presets. Unused presets are
skipped over. Note that Presets must have been previously stored.
Refer also to the item about STORING PRESETS (AM/FM/XM/DAB) at the
LISTENING TO AM/FM RADIO section of the OPERATION page.
XM mode (120V version model only)
Use the front panel [d/f] and [ENTER] buttons in combination
with the [MENU] button to select through applicable XM menu
options.
DAB mode (230V version model only)
Use front panel [a/s] and [ENTER] buttons in combination with
[MENU] button to select through applicable DAB menu options.
4 MEMORY
Press this button to store tuned AM, FM and digital radio stations to
the T 777's 40 preset-memory locations. One can store a mix of any
AM, FM and digital radio stations to the 40 available presets.
5 INFO
Show information as supplied by the applicable source.
Toggle [INFO] button to display supplied information.
8 9
VOLUME
s
B C D E
© NAD T 777
18 19