Operation; Using The T 758 - Main Menu; About The On-Screen Display (Osd); Main Menu - NAD T 758 Owner's Manual

ABOUT THE ON-SCREEN DISPLAY (OSD)

The T 758 employs a simple, self-explanatory system of on-screen display
"menus" that will appear on the connected video monitor/TV. These are
required during the setup process (and are useful in day-to-day operation),
so be sure to connect the monitor/TV before proceeding with the setup.
DISPLAY THE OSD
Press [S], [s], [MENU] or [ENTER] buttons of the AVR 4 remote control or
front panel to display the T 758's Main Menu on your video monitor/TV. If
the OSD does not appear, check your MONITOR OUT connections.
NAVIGATING THE OSD AND MAKING CHANGES
To navigate through the OSD menu options, please do the following using
the AVR 4 or corresponding front panel buttons:
1 Press [ S ] to select a menu item. Use [ D/F ] or in some cases, [ENTER],
to move up or down the Menu selections. Repeatedly press [ S ] to
advance or go further into the sub-menu of desired menu item.
2 Use [ D/F ] to set or change the parameter value (setting) of a menu item.
3 Press [ A ] to save the settings or changes done on the current menu or
sub-menu. Pressing [ A ] will also return the user to the previous menu
or exit from a particular menu.

MAIN MENU

The Main Menu contains the menu options for "DSP Options", "Tone
Controls", "Zone Controls", "System Info" and access to "Setup Menu".
Follow the guidelines about "DISPLAY THE OSD" and "NAVIGATING THE OSD
AND MAKING CHANGES" to navigate through the menu options and their
sub-menu selections.
NOTE
The individual configurations set forth at "DSP Options" and "Tone
Controls" are carried over whenever they are enabled at A/V Presets
setting. Please see the section "AV PRESETS" for reference.

USING THE T 758 - MAIN MENU

DSP OPTIONS

LIP SYNC DELAY
DSP Options has the feature "Lip Sync Delay" whose function is to match
any delay that may occur in the picture relative to the audio.
By varying "Lip Sync Delay" from 0ms to 120ms, one can delay the audio
output in order to synchronize it with the video image.

TONE CONTROLS

The T 758 has two Tone Control levels – Treble and Bass. Bass and Treble
controls only affect the low bass and high treble leaving the critical
midrange frequencies free of coloration.
These controls allow one to tweak on-the-fly, the frequency response
of the source during playback. The control setting could be adjusted by
navigating through the Tone Controls' OSD menu via a combination of
[ENTER] and [ A/S/D/F ] keys.
Maximum and minimum values for all three Tone Control levels are ±10 dB.
"Tone Defeat" gives one the choice of varying or completely bypassing
the tone control section of the T 758. If "Off" ("Tone Active" in the VFD) is
selected, the Tone Control circuits are active.
Select "On" ("Tone Defeat" in the VFD) to bypass the Tone Controls effectively
defeating the effect of the tone control circuits.
NOTE
Tone Controls options can be directly selected or changed using AVR 4's
[TONE] button with DEVICE SELECTOR set to AMP mode. Refer to front panel
display to manage tone controls. Toggle [TONE] button to select "Treble"
or "Bass" and then use the [D/F] to adjust their respective levels. Press
[TONE] again to save the settings and at the same time move on to the next
parameter or exit the parameter setting altogether.

OPERATION

15