APRILIA RST MILLE FUTURA - PART 2 2000 Manual page 30

REASSEMBLY
a
WARNING
Before proceeding with the reassembly,
make sure that the tang (7) is present
and correctly positioned. If it has come
off its seat, position it correctly. Do not
forget to put it back.
Rotate the propeller shaft in such a way
as to position the tang (7) in the upper
part.
Position the wheel (8) on the propeller
shaft, making sure that the three driving
pins (10) are correctly inserted in the ap-
propriate seats in the wheel.
Engage the first gear, to prevent the
wheel from turning.
Make sure that the tang (7) is positioned
in the appropriate seat in the propeller
shaft.
Correctly position the centering bush (9),
fitting the tang (7) in the slot (11).
Spread a film of lubricating grease on the
thread of the wheel fastening screw (6).
Manually screw the wheel fastening
screw (6).
Insert the bushing (5) into the screw hole
(4).
Insert the dynamometric spanner into the
hexagonal seat of the bushing (5).
a
WARNING
Make sure that the wheel fastening
screw (6) is tightened with the pre-
scribed driving torque.
Wheel fastening screw driving torque:
170 Nm (17.0 kgm)
Tighten the wheel fastening screw (6).
Insert the locking nut (3) in the screw
hole (4), trying to find the correct position
for the complete insertion of the nut it-
self.
Correctly position the snap ring (2).
Screw the plug (1).
a
CAUTION
Have the driving torques, centering and
balancing of the wheel checked by your
APRILIA Official Dealer, in order to avoid
accidents that may be harmful for you
and/or other people.
use and maintenance RST mille Futura 73