APRILIA RST MILLE FUTURA - PART 1 2000 Manual page 17

ã
Follow
Description
Diagnostic warning light LED
Speedometer (km/h)
Digital display
Odometer (km - mi)
(left side)
Multifunction
digital display Fuel level indicator.
(right side)
Function
Comes on for approximately three seconds whenever the ignition switch is turned to position
" ", thus testing the correct operation of the LED.
a
If the diagnostic warning light LED "EFI" comes on and blinks
CAUTION
EFI
when the engine is started or starts blinking during the normal op-
eration of the engine, this means that the electronic unit has detected an anomaly. In
many cases, the engine keeps running with reduced performance levels; immediately
contact an Official Dealer.
It indicates the driving speed.
Indicates the partial or total number of kilometres (miles) covered.
Indicates the fuel level in the tank.
The fuel quantity is shown by the indicator range (analog display) and by the
L
value expressed in (gal) (numerical display).
When the fuel tank is full the indicator range is completely on and the numeri-
)
cal display indicates " ".
As the fuel level decreases, the marked area of the indicator range and the
L
value in (gal) decrease accordingly.
When no segment of the indicator range is on, the numerical display blinks in-

dicating " " and the low fuel warning light LED blinks, this means that the
quantity of fuel left in the tank amounts to less than 4 ± 1
In this case, top up as soon as possible, see p. 28 (FUEL).
a
When no segment of the indicator range is on, the
CAUTION
numerical display blinks indicating "
low fuel warning light LED blinks, contact an
NOTE
The digital sector can be used alternatively to display the air tem-
perature (T°AIR), while the analog display remains off.
To alternate the
data displayed,
see p. 20 (SET-
TING BUT-
TONS).
L
.

" and the
Official Dealer.
use and maintenance RST mille Futura
ã
Follow
17