Dell PowerVault MD3200i Owner's Manual page 88

4 To use the IPv4 settings for the iSCSI host port, select Enable IPv4 and
select the IPv4 Settings tab.
5 To use the IPv6 settings for the iSCSI host port, select Enable IPv6 and
select the IPv6 Settings tab.
6 To configure the IPv4 and IPv6 settings:
To automatically configure the settings, select Obtain configuration
•
automatically. This option is selected by default.
• To manually configure the settings, select Specify configuration.
NOTE:
obtained automatically using the DHCP for IPv4 settings. Similarly for IPv6
settings, the configuration is obtained automatically based on the MAC
address and the IPv6 routers present on the subnetwork.
You can click Advanced IPv4 Settings and Advanced IPv6 Settings to
configure the Virtual Local Area Network (VLAN) support and Ethernet
priority. You can also click the Advanced Host Port Settings to configure
the TCP listening port settings and Jumbo frame settings.
7 To enable the Internet Control Message Protocol (ICMP), select Enable
ICMP PING responses.
The ICMP setting applies to all the iSCSI host ports in the storage array
configured for IPv4 addressing.
NOTE:
The ICMP messages determine whether a host is reachable and how long it
takes to get packets to and from that host.
8 Click OK.
88
Configuration: Using iSCSI
If you select the automatic configuration method, the configuration is
The ICMP is one of the core protocols of the Internet Protocol suite.