Download  Print this page

Viewing Storage Array Connections - Dell PowerVault MD3200i Owner's Manual

Storage arrays.
Hide thumbs

Advertisement

6 Click OK.
NOTE:
You are not prompted for a password when you attempt to change the
storage array configuration in the current management session.
Password Guidelines
Follow these guidelines when you create a password:
Use secure passwords for your storage array. A password must be easy for
you to remember but difficult for others to determine. Consider using
numbers or special characters in the place of letters, such as a 1 in the
place of the letter I, or the at sign (@) in the place of the letter a.
For increased protection, use a long password with at least 15
alphanumeric characters. The maximum password length is 30 characters.
Passwords are case sensitive.
NOTE:
You can attempt to enter a password up to ten times before the storage
array enters a lockout state. Before you can try to enter a password again, you must
wait 10 minutes for the storage array to reset. To reset the password, press the
password reset switch on your RAID controller module, see Figure 3-1.

Viewing Storage Array Connections

You can use the View Connections option to view the expansion enclosures
connected to the RAID controller module.
To view the storage array connections:
1 From the toolbar in AMW, select Storage Array View Connections.
The <Storage Array>:Connections dialog is displayed.
2 Click the column name to sort the connections according to your
preference.
3 Click Close.
If you receive an error message for a port, you can use this dialog to identify
the components on the port that may have caused the error. By isolating these
components, you prevent accidentally disconnecting components that are
still in operation, which could cause an interruption in data flow.
72
Configuration: About Your Storage Array

Advertisement

   Related Manuals for Dell PowerVault MD3200i

This manual also for:

Powervault md3220i

Comments to this Manuals

Symbols: 0
Latest comments: