Table 20-2 Snmp Traps - ZyXEL Communications ZYWALL 10W User Manual

ZyWALL 10~100 Series Internet Security Gateway
FIELD
Set Community Type the Set community, which is the password for incoming Set
requests from the management station.
Trusted Host If you enter a trusted host, your ZyWALL will only respond to
SNMP messages from this address. A blank (default) field means
your ZyWALL will respond to all SNMP messages it receives,
regardless of source.
Trap Type the Trap community, which is the password sent with each
trap to the SNMP manager.
Community
Destination Type the IP address of the station to send your SNMP traps to.
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or [ESC]
to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
20.4 SNMP Traps
The ZyWALL will send traps to the SNMP manager when any one of the following events occurs:
TRAP #
0 coldStart (defined in RFC-1215)
1 warmStart (defined in RFC-1215)
4 authenticationFailure (defined in
RFC-1215)
6 whyReboot (defined in ZYXEL-
MIB)
6a For intentional reboot :
6b For fatal error :
20-4
Table 20-1 SNMP Configuration Menu Fields

Table 20-2 SNMP Traps

TRAP NAME
DESCRIPTION
A trap is sent after booting (power on).
A trap is sent after booting (software reboot).
A trap is sent to the manager when receiving any SNMP
get or set requirements with the wrong community
(password).
A trap is sent with the reason of restart before rebooting
when the system is going to restart (warm start).
A trap is sent with the message "System reboot by user!"
if reboot is done intentionally, (for example, download new
files, CI command "sys reboot", etc.).
A trap is sent with the message of the fatal code if the
system reboots because of fatal errors.
DESCRIPTION
SNMP Configuration
EXAMPLE
Public
0.0.0.0
Public
0.0.0.0