Control Panel; Removing The Control Panel - Dell PowerVault E03J Series Hardware Owner's Manual

Control Panel

Removing the Control Panel

1 Turn off the enclosure and host server.
2 Disconnect all the power cables connected to the enclosure.
3 Remove the hard drives from:
– slots 0 to 2 in PowerVault MD1200
slots 0 to 5 in PowerVault MD1220
–
See "Removing a Hard Drive" on page 31.
NOTE:
4 Slide the control panel out of the chassis after:
– Pushing the release tab toward the front of the enclosure in
PowerVault MD1200. See Figure 3-11.
– Pulling the release pin toward the front of the enclosure in PowerVault
MD1220. See Figure 3-12.
42
Installing Enclosure Components
Mark each hard drive with it's slot position as you remove it.