Internal Usb Cable; Removing The Internal Usb Cable; Installing The Internal Usb Cable - Dell PowerVault DL2100 Hardware Owner's Manual

Internal USB Cable

Removing the Internal USB Cable

1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System".
3 Remove the fan bracket. See "Removing the Fan Bracket".
4 Remove the USB cable from the appropriate connector on the Control
Panel.
5 Remove the USB cable from the cable routing guides on the inside of the
chassis. If applicable, remove any other cables from the cable routing
guides.
6 Remove the USB cable from the connector on the system board.

Installing the Internal USB Cable

1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System".
3 Remove the fan bracket. See "Removing the Fan Bracket".
4 Connect the USB cable to the appropriate connector on the control panel.
5 Route the cable through the cable routing guides on the inside of the
chassis.
6 Connect the USB cable to the connector on the system board.
7 Replace the fan bracket. See "Replacing the Fan Bracket".
8 Close the system. See "Closing the System".
9 Reconnect the system to the electrical outlet, including any attached
peripherals, and turn the system on.
92
Installing System Components