Dell POWEREDGE 2950 Hardware Owner's Manual page 32

Table 1-7. System Messages (continued)
Message
PCIe Degraded Link Width
Error: Embedded
Bus# nn /Dev# nn /Func n
Expected Link Width is n
Actual Link Width is n
PCIe Degraded Link Width
Error: Slot n
Expected Link Width is n
Actual Link Width is n
PCIe Training Error:
Embedded
Bus# nn /Dev# nn /Funcn
PCIe Training Error:
Slot n
PCI BIOS failed to install PCI device BIOS (Option ROM)
Plug & Play Configuration
Error
Read fault
Requested sector not found
Remote configuration
update attempt failed
32
About Your System
Causes
Faulty or improperly installed PCIe
card in the specified slot.
Faulty or improperly installed PCIe
card in the specified slot.
Faulty or improperly installed PCIe
card in the specified slot.
checksum failure is detected during
shadowing.
Loose cables to expansion card(s);
faulty or improperly installed
expansion card(s).
Error encountered in initializing PCI
device; faulty system board.
The operating system cannot read
from the diskette or hard drive, the
system could not find a particular
sector on the disk, or the requested
sector is defective.
System unable to process Remote
Configuration request
Corrective Actions
Reseat the PCIe card in the specified
slot number. See "Expansion Cards" on
page 76. If the problem persists, see
"Getting Help" on page 147.
Reseat the PCIe card in the specified
slot number. See "Expansion Cards" on
page 76. If the problem persists, see
"Getting Help" on page 147.
Reseat the PCIe card in the specified
slot number. See "Expansion Cards" on
page 76. If the problem persists, see
"Getting Help" on page 147.
Reseat the expansion card(s). Ensure
that all appropriate cables are securely
connected to the expansion card(s). If
the problem persists, see
"Troubleshooting Expansion Cards" on
page 127.
Install the NVRAM_CLR jumper and
reboot the system. See Figure 6-1 for
jumper location. If the problem persists,
see "Troubleshooting Expansion Cards"
on page 127.
Replace the diskette. Ensure that the
diskette and hard drive cables are
properly connected. See
"Troubleshooting a USB Device" on
page 115, or "Troubleshooting a Hard
Drive" on page 124 for the appropriate
drive(s) installed in your system.
Retry Remote Configuration.