Dell POWEREDGE 2950 Hardware Owner's Manual page 24

Table 1-6. LCD Status Messages (continued)
Code Text
HDD ## Rbld Abrt The specified hard drive has
E1811
E1812 HDD ## Removed
E1913 CPU & Firmware
Mismatch
E1A11 PCI Rsr Config
E1A12 PCI Rsr Missing
E1A14 SAS Cable A
E1A15 SAS Cable B
E2010 No Memory
E2011 Mem Config Err
E2012 Unusable Memory
Shadow BIOS Fail The system BIOS failed to copy
E2013
E2014 CMOS Fail
E2015 DMA Controller
24
About Your System
Causes
experienced a rebuild abort.
The specified hard drive has been
removed from the system.
The BMC firmware does not
support the CPU.
PCI risers are not configured
correctly; some invalid
configurations may prevent the
system from powering on.
One or all of the PCI risers is
missing, preventing the system
from powering on.
SAS cable A is missing or bad.
SAS cable B is missing or bad.
No memory is installed in the
system.
Memory detected, but is not
configurable. Error detected
during memory configuration.
Memory is configured, but not
usable. Memory subsystem
failure.
its flash image into memory.
CMOS failure. CMOS RAM not
functioning properly.
DMA controller failure.
Corrective Actions
See "Troubleshooting a Hard
Drive" on page 124. If the
problem persists, see your RAID
documentation.
Information only.
Update to the latest BMC
firmware. See the BMC User's
Guide for more information on
setup and use of BMC.
See "Expansion-Card Riser
Boards" on page 98.
Information only.
Reseat the cable. If problem
persists, replace cable. See "SAS
Controller Daughter Card" on
page 69.
Reseat the cable. If problem
persists, replace cable. See "SAS
Controller Daughter Card" on
page 69.
Install memory. See "Installing
Memory Modules" on page 90.
See "Troubleshooting System
Memory" on page 120.
See "Troubleshooting System
Memory" on page 120.
See "Troubleshooting System
Memory" on page 120.
See "Getting Help" on page 147.
See "Getting Help" on page 147.